Solar Tracker Using Arduino And Servo Motor

The circuit diagram for the arduino based solar tracker using ldr servo motor is given below.

Solar tracker using arduino and servo motor. Ldr 2 nos. A dummy solar plate is attached in parallel to the axis of servo motor and both the sensors are kept on the dummy solar plate as shown in the figure below. Two ldr s light dependent resistor are also connected to analog pins of the arduino. Tact switch button resistors 10k 3 nos.

To track the sun i used four ldc sensors and arduino compares the data from them to rotate the panel in the direction with the most sunlight using two dc motors one for each axis and motor driver. This solar tracker system uses the arduino uno board a servomotor 2 ldrs and 2 resistors to rotate the solar panel towards the sun or a source of light. Connect 5volt pin from the arduino to the lower horizontal row of the breadboard. Since ldr is an analogue sensor they are connected to the analog pins a0 and a1 of arduino.

Extend the 5 volt and gnd rows to the upper horizontal rows of the breadboard respectively. The embedded software design the embedded software is the piece that will be embedded in the hardware arduino uno to control and monitor the solar tracker test bench. Before reading the post please check the video from my channel it gives 70 of idea about the project. It can also charge mobile phone.

Four ldrs and four 100kω resistors are connected in a voltage divider fashion and the output is given to 4 analog input pins of arduino. 5 to 12 volt power supply. The servo is controlled through one of the arduino s pwm outputs. In this project an arduino nano is used which works as a controlling unit.

Arduino solar tracker with servomotor. The circuit design of solar tracker is simple but setting up the system must be done carefully. Interfacing dual axis solar tracker arduino project using ldr servo motors. The pwm inputs of two servos are given from digital pins 9 and 10 of arduino.

Photovoltaic powers the solar tracker no external source needed. So i ve made a solar tracker using an arduino and servo motor. The sensors are connected in series with 10 k ohm resistors. Read servo motor control using arduino in the circuit two ldr light dependent resistors sensors are used to sense the light.

Similarly connect the gnd pin from the arduino to a second lower horizontal row of the breadboard. If you are simply trying this project for fun then a breadboard is perfect. The used servo motors are controlled by the arduino uno board via 3 wire electrical cable as shown in fig. This solar tracker uses two ldrs to measure the light or the resistance of the ldr changes according to the light.